chusnulamri.com

Archive for October, 2010

There are several factors that must be met before this year electric shower can be installed. First, there must be a clearance of 10 meters from the shower to the cold water source. The water source should aussi In the Have a minimum operating pressure of a bar with a flow rate of 8 liters per minute. The maximum water pressure with the closed valve is 10 bar. Almost every electric shower comes preconfigured for thesis requirements. Some may be altered by the exceptional conditions.

There are several types of electric showers. All of them connect directly to the main line of cold water. Some of them connected to a line of water heater and operate as a mixer shower, while the water Other internal heat, so that only the cold line is necessary. The pipe line should be cold hand a tube of 15 mm to make a direct connection. It is recommended, however, to install years of isolation between the main line valve and the shower so it can be sustained without having hand to cut the water line, stop all water use at home or on several floors connected.

It is recommended that the electrical connection of rain to be performed by a qualified electrician to ensure that all regulamento are being met. The show must be installed on its own circuit and can not be attributed to a circuit with other appliances. The circuit box must be rated for 60 amp connections for the show. In addition, a residual current device (RCD) must be installed as part of the circuit board fuse / or separately, a leader in the fair circuit. The connection of the shower to the circuit board must be through a circuit breaker (MCB). It is recommended that the circuit consists of a 10 mm cable. “This allows future updates to be installed shower.